BRASS

010  BRASS EAGLE ORNAMENT

Factory replaces:
Eagle Morning Pride Ben Franklin I and II
(Remove old topper, utilize existing holes and factory or included hardware)
 

017 LIBERTY EAGLE (Long)

Factory replaces: 
Long Conway American Heritage Leather and New American Classic Phenix Leather
(Remove old topper, utilize existing hardware and holes)

With Modification will fit:
Cairns / MSA, Leather N6A, Leather N5A
(Remove old topper, Must remove existing brass crown cap, place eagle on helmet and drill new holes for included hardware)

018 LIBERTY EAGLE (Short)*

Factory replaces:
Pacific Traditional Long and Short Brim, Conway American Classic
(Remove old topper, utilize existing hardware and holes)
*Mid - Late 2006 this eagle was factory changed to a 017 

021 LIBERTY 880 EAGLE

Factory replaces Cairns MSA 880:
(Remove old topper, utilize existing hardware and holes)

026 LIBERTY PATRIOT EAGLE

Factory replaces:
Patriot Chieftain 1910
(Remove old topper, utilize existing hardware and holes)

028 BRASS BEAVER

Factory replaces:
BEAVER Cairns / MSA, 1000, 1010, 1044, 
Leather N5A, Leather N6A (keep factory crown cap)
(Remove old topper, utilize existing hardware and holes)

Eagles are made in the U.S.A., not Imported!

BRONZE

014A BRONZE EAGLE ORNAMENT

With Modification will fit:
Older Plastic Cairns 880 style helmets
Old style fitted Leather Helmets without crash / impact liner or ratchet system

1. Remove old topper, drilling out head of rivets. 
2. Back out set screws on eagle.
3. Assess front leather rib as it must be smooth and consistent with the other ribs.
4. If necessary remove excess leather in small increments. 
5. Place eagle over rib ensuring that it is all the way down.*  
6. While holding eagle in place tighten screws.
*You may have to remove a wedge of leather at the leading edge of the eagle to ensure that the set screws thread into the rib and a snug fit on the shield.    

014B BRONZE EAGLE ORNAMENT

Will fit:
Old Aluminum style helmets
(Only for helmets with standard 6 inch shields)  
(Remove old topper, back out set screws, place over metal rib, and tighten screws)  

014C BRONZE EAGLE ORNAMENT

With Modification will fit:
Cairns / MSA, Sam Houston N6A, New Yorker N5A

1. Remove old topper. 
2. Back out set screws on eagle.
3. Assess front leather rib as it must be smooth and consistent with the other ribs.
4. If necessary remove the excess leather in small increments. 
5. Place eagle over rib ensuring that it is all the way down.
6. While holding eagle in place tighten screws. 

READY to ORDER